GB3EY • Re: Signal received in Waltham NE lincolnshire
Good to see that you've received EY, Roger. Did you get to the bottom of what was causing your earlier problems?The propagation tools suggested that you should be able to receive it there with a...
View ArticleGB3EY • rx of repeater test tonight using a cantenna
I went up to caistor in Lincolnshire tonight to test simple antenna the Cantenna. well happy with the results just coffee can no preamp and minitioune on a pi3 running portsdown 2020
View ArticleGB3EY • 23cm PA Module urgently needed for GB3EY
EY is currently off-air whilst intermittent sensitivity issues are traced. One of the causes appears to be a faulty Mitsubishi RF module, where its gain in the transmitter chain is fluctuating and the...
View ArticleGB3EY • Re: 23cm PA Module urgently needed for GB3EY
If you only want 400mW I think Jim G7NTG used a small 900MHz brick which, with minor mods worked well at 1250. Somewhere I bought a couple to try and somewhere I saved the webpage.......Or perhaps a...
View ArticleGB3EY • GB3EY operational
GB3EY was returned to service after repair and upgrade at 1530 UTC 18/12/2021The repeater has had the following work done to it:1. Replacement RA18H1213G module used as driver to the PA; original was...
View ArticleGB3EY • Ryde Rx repairs
GB3EY's receiver underwent surgery over the weekend of the 15/16th January.The Minitioune PCB was replaced and a new SD card was installed with the latest version of Buster and the Ryde software.A...
View ArticleGB3EY • GB3EY on air after rebuild
GB3EY was returned to service on Wednesday 24th January 2024 after two weeks off air for a rebuild.The filters, power amplifier, driver, preamp, power supplies and case have been retained, but the...
View ArticleGB3EY • Re: GB3EY on air after rebuild
Clive,Many thanks for the cross repeater QSO.Between EY and JV.It worked much better than expected an I didn't have to say"microphone back to you" once.Nice to catch up after more than 50 years.73...
View Article
More Pages to Explore .....